CO2 Adsorption on N-Doped Porous Biocarbon Synthesized from Biomass Corncobs in Simulated Flue Gas
This study was to develop a low-cost N-doped porous biocarbon adsorbent that can directly adsorb CO2 in high-temperature flue gas from fossil fuel combustion. The porous biocarbon was prepared by nitrogen doping and nitrogen-oxygen codoping through K2CO3 activation. Results showed that these samples...
| Veröffentlicht in: | Langmuir : the ACS journal of surfaces and colloids. - 1992. - 39(2023), 22 vom: 06. Juni, Seite 7566-7577 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , , , , , |
| Format: | Online-Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2023
|
| Zugriff auf das übergeordnete Werk: | Langmuir : the ACS journal of surfaces and colloids |
| Schlagworte: | Journal Article |
| Zusammenfassung: | This study was to develop a low-cost N-doped porous biocarbon adsorbent that can directly adsorb CO2 in high-temperature flue gas from fossil fuel combustion. The porous biocarbon was prepared by nitrogen doping and nitrogen-oxygen codoping through K2CO3 activation. Results showed that these samples exhibited a high specific surface area of 1209-2307 m2/g with a pore volume of 0.492-0.868 cm3/g and a nitrogen content of 0.41-3.3 wt %. The optimized sample CNNK-1 exhibited a high adsorption capacity of 1.30 and 0.27 mmol/g in the simulated flue gas (14.4 vol % CO2 + 85.6 vol % N2) and a high CO2/N2 selectivity of 80 and 20 at 25 and 100 °C and 1 bar, respectively. Studies revealed that too many microporous pores could hinder CO2 diffusion and adsorption due to the decrease of CO2 partial pressure and thermodynamic driving force in the simulated flue gas. The CO2 adsorption of the samples was mainly chemical adsorption at 100 °C, which depended on the surface nitrogen functional groups. Nitrogen functional groups (pyridinic-N and primary and secondary amines) reacted chemically with CO2 to produce graphitic-N, pyrrolic-like structures, and carboxyl functional groups (-N-COOH). Nitrogen and oxygen codoping increased the amount of nitrogen doping content in the sample, but acidic oxygen functional groups (carboxyl groups, lactones, and phenols) were introduced, which weakened the acid-base interactions between the sample and CO2 molecules. It was demonstrated that SO2 and water vapor had inhibition effects on CO2 adsorption, while NO nearly has no effect on the complex flue gas. Cyclic regenerative adsorption showed that CNNK-1 possessed excellent regeneration and stabilization ability in complex flue gases, indicating that corncob-derived biocarbon had excellent CO2 adsorption in high-temperature flue gas |
|---|---|
| Beschreibung: | Date Completed 06.06.2023 Date Revised 06.06.2023 published: Print-Electronic Citation Status PubMed-not-MEDLINE |
| ISSN: | 1520-5827 |
| DOI: | 10.1021/acs.langmuir.3c00137 |