Water reuse in the post-tanning process : minimizing environmental impact of leather production
Post-tanning wastewater is very diversified, as the post-tanning stage should meet the desirable properties of the leather for the final product, with low standardization of the process (compared to beamhouse and tanning). This makes post-tanning effluent reuse less feasible, and reuse in the post-t...
| Veröffentlicht in: | Water science and technology : a journal of the International Association on Water Pollution Research. - 1986. - 85(2022), 1 vom: 20. Jan., Seite 474-484 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , |
| Format: | Online-Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2022
|
| Zugriff auf das übergeordnete Werk: | Water science and technology : a journal of the International Association on Water Pollution Research |
| Schlagworte: | Journal Article Waste Water Water 059QF0KO0R |
| Zusammenfassung: | Post-tanning wastewater is very diversified, as the post-tanning stage should meet the desirable properties of the leather for the final product, with low standardization of the process (compared to beamhouse and tanning). This makes post-tanning effluent reuse less feasible, and reuse in the post-tanning stage still needs to be explored. This work aims to evaluate the reuse of liquid effluents in the post-tanning process. The work methodology consisted of (i) characterization of water streams (groundwater, liquid effluent after primary treatment, and liquid effluent after secondary treatment); (ii) pilot-scale post-tanning tests using groundwater, primary effluent, and secondary effluent; (iii) characterization of the residual baths from pilot-scale tests (pH, conductivity, total solids, chemical oxygen demand, biochemical oxygen demand, chloride, hardness and oil and grease); and (iv) testing the leather obtained for total sulfated ash and organoleptic properties. Results showed that the primary effluent and the secondary effluent could be reused in pilot-scale post-tanning tests. There was an increase in the conductivity of the residual baths when liquid effluents were reused, which confirms the accumulation of salts in the effluents after their reuse |
|---|---|
| Beschreibung: | Date Completed 24.01.2022 Date Revised 07.12.2022 published: Print Citation Status MEDLINE |
| ISSN: | 0273-1223 |
| DOI: | 10.2166/wst.2021.620 |