Closing the loop for PET, PE and PP waste from households : Influence of material properties and product design for plastic recycling
Copyright © 2019 Elsevier Ltd. All rights reserved.
| Veröffentlicht in: | Waste management (New York, N.Y.). - 1999. - 96(2019) vom: 01. Aug., Seite 75-85 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , , |
| Format: | Online-Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2019
|
| Zugriff auf das übergeordnete Werk: | Waste management (New York, N.Y.) |
| Schlagworte: | Journal Article Circular economy Material quality Mechanical properties Melt flow index (MFI) Plastic recycling Recyclability Plastics Polyethylene Terephthalates Polymers |
| Zusammenfassung: | Copyright © 2019 Elsevier Ltd. All rights reserved. Recycling of plastic is an important step towards circular economy. However, plastic from household waste (HHW) is a heterogeneous and contaminated resource, leading to recycled plastic with reduced quality, limiting the potential for closed-loop recycling. In addition to regulatory requirements for the chemical composition of recycled plastic, reduced physical and mechanical properties may limit the potential for closed-loop recycling. Consequently, this study analyses the thermal degradation, processability and mechanical properties of a range of reprocessed PET, PE and PP samples from source-separated plastic in HHW. On this basis, the potential for closed-loop recycling is evaluated. The study demonstrated that PET, PE and PP recycling represent different challenges. Potential degradation of the PET polymer can be reversed in a decontamination process, making PET waste well-suited for closed-loop, multiple times recycling, even when the degree of heterogeneity in the waste is high. The processability of different kinds of PE and PP packaging types varied considerably, especially for PP. Consequently, current recycling of mixed PP waste and even separate recycling of individual PP waste packaging types, will not technically facilitate recycling into new packaging products. This highlights the importance of PE and PP waste homogeneity when sent to reprocessing. Such homogeneity may be achieved through additional plastic sorting and regulatory harmonisation of product design, accounting for polymer properties and recyclability. Degradation of PP during recycling was shown to be substantial, representing another important limitation for PP recycling, necessary to address in the future |
|---|---|
| Beschreibung: | Date Completed 12.09.2019 Date Revised 12.09.2019 published: Print-Electronic Citation Status MEDLINE |
| ISSN: | 1879-2456 |
| DOI: | 10.1016/j.wasman.2019.07.005 |