An X-ray and Neutron Reflectometry Study of Iron Corrosion in Seawater
The corrosive breakdown of thin iron films supported on silicon substrates under a number of conditions is presented-in particular to understand better how iron, and hence ferritic steel, behaves in a salty water environment. A combination of X-ray and neutron reflectometry was used to monitor the s...
| Publié dans: | Langmuir : the ACS journal of surfaces and colloids. - 1985. - 34(2018), 21 vom: 29. Mai, Seite 5990-6002 |
|---|---|
| Auteur principal: | |
| Autres auteurs: | , , , , |
| Format: | Article en ligne |
| Langue: | English |
| Publié: |
2018
|
| Accès à la collection: | Langmuir : the ACS journal of surfaces and colloids |
| Sujets: | Journal Article Research Support, Non-U.S. Gov't |
| Résumé: | The corrosive breakdown of thin iron films supported on silicon substrates under a number of conditions is presented-in particular to understand better how iron, and hence ferritic steel, behaves in a salty water environment. A combination of X-ray and neutron reflectometry was used to monitor the structures of both metal and oxide surface layers and also organic corrosion inhibitors adsorbed at the iron/aqueous interface. A range of behavior in seawater was observed, including complete dissolution and void formation under the metal surface. Importantly, two simple treatments-UV/ozone or soaking in ultrapure water-were found to significantly protect the iron surface for considerable lengths of time, although evidence of pitting corrosion began after around 10 days. The underlying causes of the efficacies of these treatments were further investigated using X-ray photoelectron spectroscopy. In addition, three potential corrosion inhibitors were investigated: (i) dodecyltrimethylammonium bromide (DTAB) demonstrated no ability to protect the surface; (ii) sodium dodecyl sulfate (SDS) appeared to accelerate corrosion; and (iii) bis(2-ethylhexyl)phosphate showed an impressive level of protection (the neutron reflectometry results indicated a thick diffuse layer of surfactant of 23% surface coverage). These findings have been interpreted in terms of preferential inhibitor adsorption at cathodic and anodic surface sites (depending on the nature of the inhibitor) |
|---|---|
| Description: | Date Completed 10.09.2018 Date Revised 10.09.2018 published: Print-Electronic Citation Status PubMed-not-MEDLINE |
| ISSN: | 1520-5827 |
| DOI: | 10.1021/acs.langmuir.8b00378 |