Control of the Porous Structure of Polystyrene Particles Obtained by Nonsolvent Induced Phase Separation
Porous polystyrene microspheres were produced by a process of nonsolvent induced phase separation (NIPS) from ternary polymer-solvent-nonsolvent (polystyrene-toluene-ethanol) systems and characterized by scanning electron microscopy (SEM) and small-angle X-ray scattering (SAXS) techniques. This stud...
| Veröffentlicht in: | Langmuir : the ACS journal of surfaces and colloids. - 1992. - 33(2017), 46 vom: 21. Nov., Seite 13303-13314 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , , , , , , , , |
| Format: | Online-Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2017
|
| Zugriff auf das übergeordnete Werk: | Langmuir : the ACS journal of surfaces and colloids |
| Schlagworte: | Journal Article Research Support, Non-U.S. Gov't |
| Zusammenfassung: | Porous polystyrene microspheres were produced by a process of nonsolvent induced phase separation (NIPS) from ternary polymer-solvent-nonsolvent (polystyrene-toluene-ethanol) systems and characterized by scanning electron microscopy (SEM) and small-angle X-ray scattering (SAXS) techniques. This study provides evidence for a link between the structural morphology of the porous polystyrene particles and the polystyrene concentration in the initial solutions. A reciprocal relationship between pore diameter and polymer concentration was observed for the systems with the polymer amount below the critical chain overlap concentration, C*. Above C*, this relationship breaks down. The reciprocal relationship between porosity and polymer concentration can be used to facilitate the fine control of the void size. We demonstrate that the observed reciprocal relationship between pore diameter and polymer concentration correlates well with the relative amount of nonsolvent present in the system at the onset of the phase separation process. The pore size can be reduced and, consequently, the pore surface area can be increased either by reducing the polymer concentration in the initial solution or by decreasing the polymer molecular weight in the sample composition |
|---|---|
| Beschreibung: | Date Completed 31.07.2018 Date Revised 31.07.2018 published: Print-Electronic Citation Status PubMed-not-MEDLINE |
| ISSN: | 1520-5827 |
| DOI: | 10.1021/acs.langmuir.7b02802 |