Mesoporous TiO₂-Based Photoanode Sensitized by BiOI and Investigation of Its Photovoltaic Behavior
We reported a novel BiOI/mesoporous TiO2 photoanode for solar cells, which was fabricated with BiOI attached onto a three-dimensional mesoporous TiO2 film by a chemical bath deposition (CBD) method. BiOI was revealed as an efficient and environmental friendly semiconductor sensitizer to make TiO2 re...
| Veröffentlicht in: | Langmuir : the ACS journal of surfaces and colloids. - 1992. - 31(2015), 37 vom: 22. Sept., Seite 10279-84 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , , , , , , , |
| Format: | Online-Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2015
|
| Zugriff auf das übergeordnete Werk: | Langmuir : the ACS journal of surfaces and colloids |
| Schlagworte: | Journal Article |
| Zusammenfassung: | We reported a novel BiOI/mesoporous TiO2 photoanode for solar cells, which was fabricated with BiOI attached onto a three-dimensional mesoporous TiO2 film by a chemical bath deposition (CBD) method. BiOI was revealed as an efficient and environmental friendly semiconductor sensitizer to make TiO2 respond to visible light. Based on this photoanode, mesoporous TiO2-based solar cell sensitized by BiOI exhibited promising photovoltaic performance. Meanwhile, the optimization of photovoltaic performance was also achieved by varying cycles of deposition immersions. The highest open circuit voltage and short circuit current of the solar cell can reach 0.5 V and 1.5 mA/cm(2), respectively |
|---|---|
| Beschreibung: | Date Completed 07.12.2015 Date Revised 22.09.2015 published: Print-Electronic Citation Status PubMed-not-MEDLINE |
| ISSN: | 1520-5827 |
| DOI: | 10.1021/acs.langmuir.5b02248 |