Greenhouse gas emissions from stabilization ponds in subtropical climate
Waste stabilization ponds (WSPs) are a cost-efficient method to treat municipal and non-toxic industrial effluents. Numerous studies have shown that WSPs are a source of greenhouse gas (GHG). However, most reports concerned anaerobic ponds (AP) and few have addressed GHG emissions from facultative (...
| Veröffentlicht in: | Environmental technology. - 1993. - 35(2014), 5-8 vom: 30. März, Seite 727-34 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , , , , |
| Format: | Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2014
|
| Zugriff auf das übergeordnete Werk: | Environmental technology |
| Schlagworte: | Journal Article Research Support, Non-U.S. Gov't Gases Sewage Waste Water Water Pollutants, Chemical Carbon Dioxide 142M471B3J Phosphorus 27YLU75U4W mehr... |
| Zusammenfassung: | Waste stabilization ponds (WSPs) are a cost-efficient method to treat municipal and non-toxic industrial effluents. Numerous studies have shown that WSPs are a source of greenhouse gas (GHG). However, most reports concerned anaerobic ponds (AP) and few have addressed GHG emissions from facultative (FP) and aerobic/maturation ponds (MPs). In this paper, GHG emissions from three WSP in series are presented. These WSPs were designed as anaerobic, facultative and aerobic/maturation and were treating agricultural wastewater. CH4 fluxes from 0.6 +/- 0.4 g CH4 m(-2) d(-1) in the MP, to 7.0 +/- 1.0 g CH4 m(-2) d(-1) in the (AP), were measured. A linear correlation was found between the loading rates of the ponds and CH4 emissions. Relatively low CO2 fluxes (0.2 +/- 0.1 to 1.0 +/- 0.8 g CO2 m(-2) d(-1)) were found, which suggest that carbonate/bicarbonate formation is caused by alkaline pH. A mass balance performed showed that 30% of the total chemical oxygen demand removed was converted to CH4. It has been concluded that the WSP system studied emits at least three times more GHG than aerobic activated sludge systems and that the surface loading rate is the most important design parameter for CH4 emissions |
|---|---|
| Beschreibung: | Date Completed 10.04.2014 Date Revised 07.12.2022 published: Print Citation Status MEDLINE |
| ISSN: | 1479-487X |