Parameter analysis of the IWA Anaerobic Digestion Model No. 1 for the anaerobic digestion of blackwater with kitchen refuse

The IWA anaerobic digestion model No.1 (ADM1) had been successfully applied to the lab-scale mesophilic blackwater anaerobic digestion (BWAD) plant for cases of only blackwater (BW) feeding and of BW plus kitchen refuse (KR) feeding. In this paper, the simulation results of BW + KR anaerobic digesti...

Ausführliche Beschreibung

Bibliographische Detailangaben
Veröffentlicht in:Water science and technology : a journal of the International Association on Water Pollution Research. - 1986. - 54(2006), 4 vom: 27., Seite 139-47
1. Verfasser: Feng, Y (VerfasserIn)
Weitere Verfasser: Behrendt, J, Wendland, C, Otterpohl, R
Format: Aufsatz
Sprache:English
Veröffentlicht: 2006
Zugriff auf das übergeordnete Werk:Water science and technology : a journal of the International Association on Water Pollution Research
Schlagworte:Journal Article Fatty Acids Water Pollutants
Beschreibung
Zusammenfassung:The IWA anaerobic digestion model No.1 (ADM1) had been successfully applied to the lab-scale mesophilic blackwater anaerobic digestion (BWAD) plant for cases of only blackwater (BW) feeding and of BW plus kitchen refuse (KR) feeding. In this paper, the simulation results of BW + KR anaerobic digestion are presented and discussed, followed by the analyses and discussion of the critical and important parameters as well as the performance of ADM1 based on these results. The raw BW can contain up to 30% short chain fatty acids (SCFA) which severely impact the performance of the model. The model proved that the disintegration/hydrolysis rate of BW is around 4.5 d(-1), which is about ten times higher than that of KR (Kdis,KR = 0.5 d(-1)). ADM1 is not sensitive to the distribution ratio among carbohydrates, proteins and lipids. For BWAD the C4 metabolism can be integrated in the uptake of LCFA. The uptake delay phenomenon was observed and cannot be simulated by ADM1, but it is tolerable. No unique KI,NH3,ac is found out for all investigated ammonia concentration ranges. Meanwhile, ADM1 is not sensitive to KLa and kp1 so they can easily be set up
Beschreibung:Date Completed 19.12.2006
Date Revised 17.09.2019
published: Print
Citation Status MEDLINE
ISSN:0273-1223