Factors controlling the formation and stability of air bubbles stabilized by partially hydrophobic silica nanoparticles
Air bubbles have been formed using partially hydrophobic silica nanoparticles as the stabilizer. The particles were of primary particle size 20 nm, chemically treated to different degrees with dichlorodimethylsilane to render them partially hydrophobic. Above a certain bubble size range (typically 8...
| Veröffentlicht in: | Langmuir : the ACS journal of surfaces and colloids. - 1992. - 20(2004), 20 vom: 28. Sept., Seite 8517-25 |
|---|---|
| 1. Verfasser: | |
| Weitere Verfasser: | , , |
| Format: | Aufsatz |
| Sprache: | English |
| Veröffentlicht: |
2004
|
| Zugriff auf das übergeordnete Werk: | Langmuir : the ACS journal of surfaces and colloids |
| Schlagworte: | Journal Article |
| Zusammenfassung: | Air bubbles have been formed using partially hydrophobic silica nanoparticles as the stabilizer. The particles were of primary particle size 20 nm, chemically treated to different degrees with dichlorodimethylsilane to render them partially hydrophobic. Above a certain bubble size range (typically 80-microm diameter), the bubbles seemed to be almost indefinitely stable, while for any size above 20 microm their stability against disproportionation is far better than bubbles stabilized by any protein film investigated in previous studies. A possible theoretical justification for this observation is presented. Bubbles could be formed by shaking water with the particles, but a much higher volume fraction of bubbles was obtained by pressurizing the aqueous phase to 5 atm overnight followed by suddenly releasing the pressure to nucleate bubbles within the silica dispersion. Sonicating the silica dispersion before nucleation also gave more bubbles, which were also found to be more stable. There appeared to be an optimum degree of surface hydrophobicity that gave maximum foamability and foam stability, where around 20-33% of the silanol groups on the silica surface had been converted to dimethylsilane groups. However, a sharp increase in stability occurred when between 1.8 and 2 mol dm(-3) NaCl was also included in the aqueous phase. The change in stability due to inclusion of salt can be rationalized in terms of changes occurring in the value of the particle contact angle. The effects of increasing sonication and an optimum surface chemical treatment can be explained by the need to make the particles sufficiently hydrophobic so that they adsorb strongly enough, while at the same time minimizing their tendency to aggregate in the bulk aqueous phase, which hinders their adsorption. Furthermore, confocal laser scanning microscopy of the bubble dispersions suggests that a large volume fraction of stable bubbles is only formed when the particles adsorbed to the bubbles are also part of a spanning silica particle network in the bulk aqueous solution, forming a weak gel with a finite yield stress |
|---|---|
| Beschreibung: | Date Completed 21.08.2006 Date Revised 21.09.2004 published: Print Citation Status PubMed-not-MEDLINE |
| ISSN: | 1520-5827 |